Custom Applications Available – Can't find an APR Front Wind Splitter applications for your car? APR can create custom Front Wind Splitters for any application.
Please follow the instructions below:
1. Find a large sheet of cardboard.
2. Place the cardboard underneath the front bumper.
3. Draw the bumper bottom outline onto the cardboard.
4. Fold up the cardboard and send it to us at:
APR Performance, Inc.
21037 Commerce Pointe Dr.
Walnut, CA 91789
Estimated working time:
2 weeks.
Additional Guidelines:
*For non-honeycomb splitters:
- Width cannot exceed 72”.
- Depth beyond 24" is subject to additional material charge of $25 for every 2" of depth.
*Bottom of the bumper requires at lease 3”~ 4” of flat surface all around to mount the splitter.
*Fold your template in the center to check if both curves match each other.
Description:
To combat the effects of front end lift, APR Front Wind Splitters are utilized to give extra traction and control in the front of a car. By creating a high pressure area on top of the wind splitter, high pressure air flow is restricted to flow underneath a car. With low pressure below the car, the effect of lift is reduced and a driver can gain from the extra traction and control.
Features:
- Carbon Fiber Reinforcement
All APR Front Wind Splitters are reinforced with sheets of carbon fiber.
- Fully Functional Undertray
Our Front Wind Splitters are not just add on cosmetic pieces. Every APR Front Wind Splitter completely covers the entire area below a cars front bumper. This allows for smoother air flow below the front bumper, creating more efficient downforce.
- Support Rods Included
Supporting every APR Front Wind Splitters are stainless steel Support Rods.
